Excess oil in Blueridge setup
#1
Thread Starter
Excess oil in Blueridge setup
So I recently installed my Blueridge oil catch can setup on my higher mile ap1 with a P-Tuning setup on it. It has 2 10AN bungs on the front of the valve cover and the stock breather is now blocked off. First few times I had the car out with the setup I still had a filter on the stock valve cover breather. I know my motor is down on compression on cylinder 2. 1,3, and cyl 4 are all at around 220 and 2 is at 178-180. Obviously I know this is not ideal but have had several repuable sources say its not dire and I dont need to panic. Well I just took off the breather filter on the catch can and its almost 3/4 of the way full! Im wondering if I possibly have something routed wrong or is this common for blow by to accumulate this much. I have added an extra quart of oil since the last oil change so I know now where it went lol. Oh and the stock PCV valve is hooked up in the factory location.
Any words of advise? BESIDES rebuild my motor? Thank you!
Any words of advise? BESIDES rebuild my motor? Thank you!
Thread
Thread Starter
Forum
Replies
Last Post
IntegraR0064
S2000 Under The Hood
10
06-16-2015 08:07 AM