What did you guys use as adhesive to put the side S on the front and rear where the H used to be?

Thanks,

Greg

 

I just used some gasket maker which holds it just fine. I did that because I didn't have anything else. I would use some 3m emblem adhesive tape stuff. Will hold it for sure!
Looks good painted black too. Took mine off and re did it in flat black and looks better imo.

 

i used 3m doubblesided tape man my s is my dd for over a year with the emblem on been through rain sleet and snow alot and its fine! see


oh i painted mine black 2

 

Take it to a body shop.... They will fill the holes / repaint the front bumper for around 400.

 

haha didnt even see that before i like it 2 imo

 

or you can cover it with the stock side badges for free!

 

ok so dumb question here, what did you do to snap the pins out on the H emblems.
They seem to be pretty well engaged.
Is there nothing to it but prying the H or did you snap them with something underneath first.

Greg

 

OK so I went ahead and got tough on my front badge. Mine was held on by some very stubborn rivets. they will break however with enough coaxing.
The rear is held on by a couple much less formidable looking white pins which looks like will pop out without much of a fight.
I dont have my 3M adhesive yet so Im not going to take that one off. Tomorrow morning I will be buying the adhesive. I just wanted to make sure I could do it without much issue.
Ive already take the S2000 off both fenders and they look great. I will be putting the S in place front and back tomorrow.

Greg

 

hmmm.. makes me want to remove the emblems off the CR

 

I actually bought black CR side emblems off htguy