View Full Version : S2000 Under The Hood
- Is my block done?
- Lost keys, AAA says they can cut new key?
- Rear wheel bearing and hub replacement
- Need an affordable ring job near franklin/Murfreesboro TN
- HELP! Are these ap1 or Ap2 retainers?
- HELP! Are these ap1 or Ap2 retainers?
- AP1 rod knock: Rebuild vs Replace need advice
- Rain
- ETX16 w/ OEM Mounting?
- Race Ramps RR-56
- ECU and O2 sensor issues
- Ap2 Valve retainer upgrade
- AC Compresser Troubles
- Cleaned vtec solenoid and found little black specks in the screen... what could it be from?
- Top starter bolt
- no power below 3000rpm
- need help! swapped ap2 motor into ap1. won't crank
- Drove around with clutch reservoir cap off
- Bad Input Shaft Bearing?
- Kodokan Seat locks problem
- Dealership told me to replace intake camshaft and rollers but it looks OK to me
- AP1 leaking gasoline from the rear
- NEW Slave clutch hose leaking at banjo bolt
- FIXED: P0302, 3, 4 - bad #3 pack
- Oil and coolant
- Compression test was good, do I need to do a leakdown test as well?
- Got P2183 on my 06 with 60k miles
- Compression test, then more problems!
- Ignition or immobiliser issues?
- Need Speedometer Recalibration?
- Misfiring Fun Times...
- Clicking when going on/off throttle at low RPMs
- How do my spark plugs look?
- Berk HFC Spring Compression Warning & Fix
- Front subframe bent?
- delete idle air control valve
- VTEC Inconsistency
- Diagnosing TCT Question
- One Minute Maintenance Videos
- Air Box Mods
- Bonnet wont open!
- Clutch buzz / rattle when launching?
- Belt autotensioner problem
- Car Stalling after accelerating
- Second set of eyes for timing alignment!
- Diff fluid change issue
- Flashing CEL and noise
- o2 sensor compatibiltiy
- condenser fan fuse keeps blowing
- Knocking sound from engine head area (Video)
- help with vibration
- Valve adjustment. Good time to also upgrade retainers?
- Spark plug o rings, seals
- Removing AP2 Valve Cover Hints/Tips/ I need help?
- Dropped retainer cotter! Oh NOOOOOOO!
- NEVER use a siphon tube in the dip hole in the valve cover.
- Rust in gas tank what to do
- Squeal from the front
- Clutch upgrade
- Engine ticking noise need help! video inside
- AP1 and AP2 prop shaft
- Pasword JDM Intake v Oil cooler
- Car won't start... all of a sudden
- Radiator Fan Not Coming on With Thermostat - Only AC
- No EPS - Attempting to Diagnose Problem
- Coil Pack Info Needed
- strange car sound when starting engine - with Video
- AC/Air pump/ coolant problems
- Cylinder Head Resurfacing Question
- Anyone installed engine/transmission while connected?
- snakey at highway speeds when accelerating
- Upgrading valvetrain, good investment?
- Replacement Radiator
- Parking brake handle loose
- old fuel
- Help Idle air control valve IACV part #'s
- Vibration from rears under load 4000rpm>
- Low Idle After Spark Plug Change
- Steering wheel alignment
- Tail lights issue
- Tapping after rebuild
- rattle/buzz ~4k rpm
- Front end shaking/vibrating. Intermittent. Update. Loose wobbling caliper?
- another VSA thread
- what is this clicking noise?
- Does this picture of my head look off?
- P1457 cel, now car starting then dying?
- What Radiator Fluid BESIDES Honda OEM?
- Is this the TCT Sound? (my car)
- P0135 and Running Rich
- S2000 OIL Pressure, No Vtec issue
- Developed a Noise
- missing bolt on top of airbox
- Over rev - Ticking sound from 2-3k
- 2nd gear crunch.
- What keepers do I use?
- Replacing exhaust manifold (header) - what parts are needed?
- Where are my ABS guys?
- Driver's side axle
- Very subtle misfire under acceleration
- Code P0301/P1399 was a bad coil pack
- Problem Idling when Clutch...
- For Password JDM PowerChamber owners; please check.
- Idle problem on start
- P0420 and P0133
- Help diagnose car not starting/cold start issue
- Air pump hose to intake
- Too Much oil?
- tranny? clutch? or sensor?
- Intake Related Relocation?
- Side to side throw of the Shift Lever different for 2-3 and 4-5 gear shifts
- Ap1 tct bad again
- Compression test question
- Gas tank not filling up all the way
- Anyone Running Redline Oil in their S2000 ?
- Tricks to remove dowel pins from cam caps?
- Seat belt replacement under warranty advice
- No cabin heat
- o2 sensor
- New owner questions!
- Rear Bumper Rests?
- Coil pack harness help!
- Air Conditioning cluster not lighting up
- Keyless (remote) entry
- Bolts on engine cover
- serpentine idler pulley
- Thrust bearing / clutch release bearing..
- coolant bleed valves
- Timing Chain Guide and Tensioner Arm Maintenance?
- Dropping clutch while shifting through the gears
- Sunk Valve Retainer? (Pictures Inside)
- Clutch Pedal Modification
- engine noise your thoughts please!
- Freshly rebuilt engine, knocking after 1k miles
- Optimum VTEC engagement point?
- Horrible MPG..
- Alternator dying?
- Awful smell coming from the S
- need help finding part number for missing bolt
- NO VTEC
- sponge clutch pedal
- Engine braking noise
- Ballade Sports Billet Aluminum Heavy Duty Timing Chain Tensioner.....any one have them?
- bad wheel bearing?
- Rear End Vibration + New Lowering Spring Install
- Rear main seal leak
- Does the ap1 have shorter shift throws than the ap2 s2k
- CEL->Misfire->Bad coils
- Grinding while shifting into 3rd & 4th Gear
- S2000 Start up problems
- Possible dead fuel pump?
- Whining
- S2000 won't start!
- motor randomly hesitent
- Oil Leak
- Engine noise video clip
- Ignition Tumbler change. DIY possible?
- Should i be concerned? (Differential)
- Is the price right? Engine replacement.
- Clutch Pedal Retrurn Woes
- Topside Oil Changer
- How do you fix clutch buzz?
- 2000 AP1 Rebuild Project - Advice?
- What is the purpose of the metal plates hiding/covering the softtop motors?
- Water pump pulley wobble while idling
- Would this be the TCT gone bad?
- Softop leak
- Maintenance of bushings
- Ballade Sports Heavy Duty Inboard CV Joint Assembly - any experience?
- Hose with nothing connected to it?
- s2k clutch fork position
- Killing ECU's!
- DIFF-TRANS Fluid change
- Oil change frequency
- Code P1367
- Engine light?
- no head lights?
- serpentine belt, spark plugs replacement
- Rust between master cylinder and brake booster
- Loud Valves?
- Torque sensor seemingly misaligned
- Spun a rod bearing, need some insight please.
- P0420 and P1410 after exhaust and intake install
- Noise coming from transmission?
- 9:1 Comp Ratio
- Dead battery after long winter in car. (not disconnected)
- Motor is leaning towards passenger side more why ? HELP
- 1st gear low rpm hesitation.
- Camshaft Cap Crack - Pictures Inside
- Where is This Leak From?
- motor mount slightly off the holes
- Bad alternator diode(rectifier)
- Frozen/seized caliper bolts
- Low compression, rebuild?
- All Cylinders MisFire, Not Starting HELP
- AP2 Cylinder 1 Misfire
- Did a diff fluid change...
- Made the trip to TN to see Jordan - outpatient full head swap - completely worth it!
- Dead bugs inside headlight
- Transimission syncros
- S2000 cranks
- Stupid Mistake While Pulling The Valve Cover
- 2006 differential oil showing lots of iron
- I really need some help!
- 2nd and 3rd gear sticks in when stopping the car
- Heater stuck on warm/ HCV cable doesn't move
- Throwing out baring to fork to hook diagram ?
- A/C Diagnosis
- AC Compressor Replacement
- rough idle
- Clutch - Do I need a GUIDE, RELEASE BEARING
- rough idle
- Halfshaft Slop
- did i get burned? semi newb needs help
- replaced slave and clutch master
- Propshaft Orientation
- Engine Ticking
- Will an AP1 clutch slave hook up to an AP2 hose?
- ap2 motor w/ ap1 trans
- Car behaves better when cold
- Clunk going into third gear!
- S2k not going into gear when on HELP PLEASE
- S2k not going into gear when on HELP PLEASE
- trouble with third...
- Low rpm on startup (vid)
- Rear break problem
- Drove a long way on the spare—how screwed is my diff?
- Need help with possible diff issue!
- Power Steering problem
- clunks from the rear
- AC Problem
- Clutch fork slipping halfway please help
- Ac relocation
- Clutch and Transmission PLEASE HELP
- e brake light?
- Vtec didn't engage, hesitation in vtec, knocking?
- Installed my aem wideband. Need advice
- Fuel Tank Construction ?
- Back Panel Screws OEM Hardtop Install
- Fuel Leak..
- Metal Rod Dragging
- High Idle after tb and intake mani install
- HELP: Turn signals/hazards not working
- I really need some help guys
- VSA causing tire, "wobble?"
- eps problems
- S2000 ignition lock sporadic failure?
- Need a little help - P0117/P0118
- Ballade Sports *** BRAND NEW*** Billet Aluminum Heavy Duty Timing Chain Tensioner
- Vtec cross over