View Full Version : S2000 Under The Hood
- Replace VC gaskets when checking valve clearances?
- Hard knock sound, -01 F20C
- mobil 1 high mileage?
- Shifting from 1st to 2nd
- Need the part# of this screw
- AP2 ECU Replacment
- Rate my retainers
- Fuel tank not filling all the way?
- Different Soft Top Tear
- Valve gasket and valve adjustment
- Ap1 for Ap1 Engine Swap - What stays, what goes?
- Cooling system refiller air compressor size
- Squeaky UCA bushing
- Loud Differential Noise
- VIDEO - noise when clutch disengaged after changing clutch master cylinder
- FX300 Clutch Buzz
- New motor, lots of CEL's
- Chasing Valve noise. Any help appreciated
- Going to replace tranny/diff fluid this weekend..
- Extremely Poor Idle; Looking for Last Resorts
- This is crazy, but Oil Burn? The Story of conquering phantoms.
- Anybody know how to bypass ELD
- Coolant leak?
- Smoke on takeoff
- Another misfire thread...
- Odd Compression Test Results
- Shifter won't go into 5th or reverse after regrease
- Walbro 255 + OEM Sock
- Need Help With Cam Timing Issue And Also Have A Question About Old Fuel
- Loud vibration/rattle when decelerating/accelerating around 2-4k RPM
- ACT Clutch disc with OEM PP
- AP2 Valve adjustment
- Rotor temperatures
- Failed DEQ/smog today...
- Buying a used unknown engine or JDM to swap- Crazy?
- Inspecting Transmission before install
- Need Help With Setting Timing And Position Of Colored Timing Chain Links
- Squeaking Clutch After Install
- Replacing lower radiator hose clamp
- Parasitic power losses
- noise when vtec kicks in?
- Oil on Serpentine belt
- Crashed s2k What all needs changed?
- Pedal is sticky at start?
- Need advice on aftermarket head gaskets and stock bore size
- Could someone tell me what this part is?
- No A/C, no Heat ...no bueno!
- Engine Problem - Video Inside
- Wheel Bearing and Hub Replacement
- Random Power Off and Engine Shutdown?
- Aftermarket fuel rail suggestions
- AP1 hesitation at 2.5k rpm
- Violent idle vibration after accident
- Low Compression Test Results
- Re-Gluing Glass Rear Window to Fabric
- Question about head machining service marks
- Low Battery Warning Indicator
- Diff oil weight recommendation? 2018
- Is this a coolant hose?
- CEL issues
- Infamous AP2 06+ Hesitation Update
- Alignment Problem with Caster
- Power Loss after Hitting the Rev Limit?
- VSA light after battery change
- For anyone with flashing CEL ans missfire.
- Half shaft spacers at stock ride height?
- Bought another S2000 and here are the compression numbers
- Blown HG??
- idle with AC
- Speedometer WAY too fast
- Cooling fan issue, need help.
- ABS light on, but EPS light blinks when jumping OBD2 pins
- Clear Side Markers Bulb Color?
- High RPM acceleration hesitation
- Stock Engine Mount Spacing
- Air pump valve wiring
- Hardly starts/idle drops
- AEM Infinity is playing dead
- Cometic gasket
- Billman TCT
- Nasty rattle from transmission. Please Help!
- Real Denso Coil Packs?
- Oil filter help
- Need a new engine- what to look for to make sure I get a good one?
- Velcro Strips On Soft Top.
- Vibration from drive train(I think)
- Radiator fan switch
- Rough clutch only when car is on
- VSA after engaging clutch on lift.
- No camber help!
- p1367
- Fuel pump cutting out, need OEM 2-pin connector
- Valve seal leakage??
- Water leaking into trunk in heavy rainfalls
- Oil change with a fluid extractor
- Question about Rear brake piston/cylinder
- AP2 Transmission Rebuilt, notchy gears when cold
- Tips for solo transmission reinstall?
- Radiator fan wiring
- Double check my maintenance list, please!
- A Different SRS Light Issue - It Doesn’t Come On
- Cylinder FRP Gouge - Salvageable?
- Engine cut out while driving, no warning, green key light flashing.
- Bought an engine rebuilt by a random shop, and then. . .
- Rebuild time?
- Power Loss
- Bled clutch, new MC, working SC, won't fully disengage.
- Anyone using with liqui moly 5w40 oil?
- Diff rebuild/repair advice needed
- Disappearing coolant + running cold???
- Noise Diagnosis from rear tire
- Found an odd valve spring while swapping retainers
- Speedometer way off double speed
- Rattle at 2500-3500 rpm
- Clicking / Clunking coming from rear
- Video of my cracked K&N oil filter
- Intermittent immobilizer problem
- Is this normal?!
- Confirming an ECU Reset?
- Anyone ever jumped timing on clutch job?
- Correct Wiring for dual Spal Fans with 2 relays
- S2000 Steering Angle Sensor Replacement
- Passenger rear camber adjustment issue
- August 2018 battery
- Vibration at 70MPH... thoughts?
- 01 AP1: Cranks but doesn't start on warm engine.
- Driver side turn signal, parking light, and side marker light not working?
- Car run too rich after clutch changing
- Possible Prop issue
- TCT or VTEC solenoid gasket please help
- Turbo -> NA Checklist
- No power at all after jump start
- 03 s2000 p0131 cel
- Engine Blew: Rocker arm and Valve Causes?
- Sticky clutch while shifting; now stuck to floor
- cranking issue
- Tanabe Medalion Touring vs HKS Hi Power Dual
- Will this make a noise while driving and if so, how do I fix it?
- looking for good mechanic in/near Chicago for my 2004
- 2001 S2k sat for 5 years
- K&N FIPK intake
- Bad rear diff, axles or...
- Anybody know where the alternator is grounded?
- Thread size for fuel pressure gauge
- Soft Top Patch Visability
- Front Parking lights not working unless using hazard or turn signal
- Strange metallic noise on when revving?
- How worn are my brake pades? Time to replace?
- Safe to drill in this part of footwell?
- Need Help w/ Installing AP1 Head On A 2006 Bottom End
- CEL After Valve Adjustment
- Burning Oil and Smoking Blue
- My07 cranking but won’t start
- Brand new battery, car won't start, but will if I jump start....
- CEL code 1457
- Turning off the engine - Cooler fan?
- 2001 Honda S2K noise from rear
- Reverse Shifting Problems
- Petrol/Gas strong smell!
- HOTT engine bayy
- Best clutch and flywheel for turbod s2000
- Royal Purple question
- New Hood
- UOA Results - high metal levels
- Berk HFC Install Question Help!
- Have you bled your brake master cylinder and gotten improved results?
- Flashing Green Key: Cranks but won't start
- Were ap1 and ap2s CANbus tach signals?
- Cylinder #2 rod bearing failure again :-(
- Looking for some help with engine noise
- IG Coil fuse
- Open the door - water drips
- Compression Test - How important is it for the engine to be at operating temps?
- Orange VS Clear Side Markers
- Normal?
- Squeaky Clutch Master - NOT SLAVE/FORK
- P0139 O2 Bank 1 Sensor 2 Questions
- My car started smelling burnt and fan stopped working
- Devouring oil - 1 quart every couple hundred miles
- OEM plus engine formula
- Timing chain dilemma
- P0135 Will NOT go away!
- Gravity brake bleed - crap?
- Over-torqued IACV Bolt
- Engine overhaul and reliabylity
- I think my primary oxygen (O2) sensor is failing
- Help with idle!
- Fuel pump help
- Brake Feel - Takes 100% of pedal travel in order for me to brake hard enough for ABS
- Transmission fluid leak.
- Driveshaft(?) Making Huge Grinding Noise
- Ballade TCT Spring Compatible to OEM Spring???
- Trying to install Modifry soft top straps, but the rivets are filled??
- Noises, what could it be?
- Battery suddenly died (good voltage with no cranking amp)
- Pulsating rubbing noise from rear
- Intermittent Sputtering in VTEC... MAP Sensor?
- Stock Exhaust - SUS409 or SUS304?
- Thought the tranny blew...
- intermittent hesitation(jerking, bucking) at low rpm. +fix
- Hot start issue
- P1454 - reset. Didn't come back. Concerns?
- Anyone know the brand of these heim joints (end links)?
- Turbo or supercharger? How to Pick What's Right for You
- HKS Hi Power Dual + Test Pipe!
- Headlights HID adjuster (EE - JJ)
- EPS Intermittent to Total Failure
- Idle
- Timing Chain Tensioner Bolt Help
- Correct timing
- 2008 CR engine in ap1
- Rear self leveling bolts?
- converting OEM exhaust to 3 piece by cutting and welding in flanges?
- Help needed, everything broke
- Head off, clean valves, pistons, anything else?
- Tenioner pulley indicator position
- Fuel Cap Replacements
- Rebuilt Nightmare
- 6th Gear Issue - Ideas?
- Rear diff hot
- rear wheel bearing click with no history - torque or replace?
- S2000 Vacuum lines
- Metal In My Oil
- One Rear Wheel Sits Further Out Than the Other ???
- replacing the button on clutch arm that activates the starter when clutch petal
- Really need help w/ head gasket thickness/piston to valve clearance & timing chain
- Head Bolts
- Milled Head ?
- 2004 ap2
- steering rack / torque sensor play
- Calipers: New or Recon in UK
- Scraped frame rails
- Identifying this exhaust.
- Hardware keeping Turbo+Manifold together keeps backing off - 2nd time!
- Lambda sensor garage costs
- Over torqued Axle nut FYI
- rear diff whine on overrun
- higher rear diff ratio
- 02 ap1 s2000 2nd & 3rd gear grind & 6th won’t go in.
- need help
- Fixed - metallic ringing sound from right rear of car
- Fixed - push clutch to floor, hear metallic clack noise
- Rattle Buzzing sound
- Sakebomb Ohlins FSport - No Spring Perch
- J's Racing vs. Toda Torquie-Kun Headers ?
- Clutch free play - help!
- ABS Modulator Control Unit Bleeding
- CAT CEL's Came and Went
- Front axle nut
- Bad PCM.