View Full Version : S2000 Under The Hood
- Vibration at 70MPH... thoughts?
- 01 AP1: Cranks but doesn't start on warm engine.
- Driver side turn signal, parking light, and side marker light not working?
- Car run too rich after clutch changing
- Possible Prop issue
- TCT or VTEC solenoid gasket please help
- Turbo -> NA Checklist
- No power at all after jump start
- 03 s2000 p0131 cel
- Engine Blew: Rocker arm and Valve Causes?
- Sticky clutch while shifting; now stuck to floor
- cranking issue
- Tanabe Medalion Touring vs HKS Hi Power Dual
- Will this make a noise while driving and if so, how do I fix it?
- looking for good mechanic in/near Chicago for my 2004
- 2001 S2k sat for 5 years
- K&N FIPK intake
- Bad rear diff, axles or...
- Anybody know where the alternator is grounded?
- Thread size for fuel pressure gauge
- Soft Top Patch Visability
- Front Parking lights not working unless using hazard or turn signal
- Strange metallic noise on when revving?
- How worn are my brake pades? Time to replace?
- Safe to drill in this part of footwell?
- Need Help w/ Installing AP1 Head On A 2006 Bottom End
- CEL After Valve Adjustment
- Burning Oil and Smoking Blue
- My07 cranking but won’t start
- Brand new battery, car won't start, but will if I jump start....
- CEL code 1457
- Turning off the engine - Cooler fan?
- 2001 Honda S2K noise from rear
- Reverse Shifting Problems
- Petrol/Gas strong smell!
- HOTT engine bayy
- Best clutch and flywheel for turbod s2000
- Royal Purple question
- New Hood
- UOA Results - high metal levels
- Berk HFC Install Question Help!
- Have you bled your brake master cylinder and gotten improved results?
- Flashing Green Key: Cranks but won't start
- Were ap1 and ap2s CANbus tach signals?
- Cylinder #2 rod bearing failure again :-(
- Looking for some help with engine noise
- IG Coil fuse
- Open the door - water drips
- Compression Test - How important is it for the engine to be at operating temps?
- Orange VS Clear Side Markers
- Normal?
- Squeaky Clutch Master - NOT SLAVE/FORK
- P0139 O2 Bank 1 Sensor 2 Questions
- My car started smelling burnt and fan stopped working
- Devouring oil - 1 quart every couple hundred miles
- OEM plus engine formula
- Timing chain dilemma
- P0135 Will NOT go away!
- Gravity brake bleed - crap?
- Over-torqued IACV Bolt
- Engine overhaul and reliabylity
- I think my primary oxygen (O2) sensor is failing
- Help with idle!
- Fuel pump help
- Brake Feel - Takes 100% of pedal travel in order for me to brake hard enough for ABS
- Transmission fluid leak.
- Driveshaft(?) Making Huge Grinding Noise
- Ballade TCT Spring Compatible to OEM Spring???
- Trying to install Modifry soft top straps, but the rivets are filled??
- Noises, what could it be?
- Battery suddenly died (good voltage with no cranking amp)
- Pulsating rubbing noise from rear
- Intermittent Sputtering in VTEC... MAP Sensor?
- Stock Exhaust - SUS409 or SUS304?
- Thought the tranny blew...
- intermittent hesitation(jerking, bucking) at low rpm. +fix
- Hot start issue
- P1454 - reset. Didn't come back. Concerns?
- Anyone know the brand of these heim joints (end links)?
- Turbo or supercharger? How to Pick What's Right for You
- HKS Hi Power Dual + Test Pipe!
- Headlights HID adjuster (EE - JJ)
- EPS Intermittent to Total Failure
- Idle
- Timing Chain Tensioner Bolt Help
- Correct timing
- 2008 CR engine in ap1
- Rear self leveling bolts?
- converting OEM exhaust to 3 piece by cutting and welding in flanges?
- Help needed, everything broke
- Head off, clean valves, pistons, anything else?
- Tenioner pulley indicator position
- Fuel Cap Replacements
- Rebuilt Nightmare
- 6th Gear Issue - Ideas?
- Rear diff hot
- rear wheel bearing click with no history - torque or replace?
- S2000 Vacuum lines
- Metal In My Oil
- One Rear Wheel Sits Further Out Than the Other ???
- replacing the button on clutch arm that activates the starter when clutch petal
- Really need help w/ head gasket thickness/piston to valve clearance & timing chain
- Head Bolts
- Milled Head ?
- 2004 ap2
- steering rack / torque sensor play
- Calipers: New or Recon in UK
- Scraped frame rails
- Identifying this exhaust.
- Hardware keeping Turbo+Manifold together keeps backing off - 2nd time!
- Lambda sensor garage costs
- Over torqued Axle nut FYI
- rear diff whine on overrun
- higher rear diff ratio
- 02 ap1 s2000 2nd & 3rd gear grind & 6th won’t go in.
- need help
- Fixed - metallic ringing sound from right rear of car
- Fixed - push clutch to floor, hear metallic clack noise
- Rattle Buzzing sound
- Sakebomb Ohlins FSport - No Spring Perch
- J's Racing vs. Toda Torquie-Kun Headers ?
- Clutch free play - help!
- ABS Modulator Control Unit Bleeding
- CAT CEL's Came and Went
- Front axle nut
- Bad PCM.
- Will EP3 brakes fit on an s2000
- 2001 AP1 hesitation and stuttering at low RPM
- A Few Mechanical Concerns
- Help! Getting a flooded engine.
- F20C Low Oil pressure shut down
- Steering not working well
- Quick Wheel Bearing Question...
- Stuck Rear CV Joint/Bucket (Solution with Pics)
- Accelerator pedal position sensor replacement
- Oxidised Aluminium
- Replace piston rings to fix AP1 oil consumption?
- Rebuilt motor making this noise- clip attached
- OEM seat tracks... that's right, OEM
- LS Swap S2K - Questions to get started
- ballade sports big bore throttle body .27 volts = % ?
- Help identify leaking coolant hose
- PLS HELP! 05 cranks but wont start
- NEED HELP: Fuel pump not priming after hitting dip
- Random heat-ups
- Odd noise - transmission bearing?
- What type of test pipe is this?
- Flashing CEL during prolonged VTEC use (3rd gear+)
- Horn Not Working
- Bent Something?
- Timing Chain Guide - bolt torque?
- How hard to replace rear wheel bearings?
- Suggestions for a rough running 00 ap1
- Cometic 87.5mm vs OEM 87mm
- Steering torque sensor
- Overheats when accelerating
- Overheats when accelerating
- Is this Normal Noise after Valve Adjustment
- Opinions please - Another engine noise to diagnose!
- AP2 burning oil
- SpinTech Mufflers?
- Another engine ticking noise thread
- Not sure what's going on
- Swapping Low Mileage Engine !! How should i prep before install ???
- Sheffield Area Servicing?
- DIY Starter Service - Not a Dime Spent - Pics Included
- Limp Mode
- Wheel bearing direction which side?
- Front subframe bolts
- Cleaned IACV - Parts Fell Out?
- AP1 Modifry ECT fix incorrect bar count
- Where the hell is this oil coming from????
- AP1 Taillight Lens on AP2 Tails?
- P1457 and p1129. Put my car in limp mode. Help
- S2000 hardtop metal side molding removal
- Question on Idle Relearn, Gas Mileage After Several Things Done
- Name this bolt- help solve a mystery
- Stock Oil Filter/Cooler Bolt Torque?
- Stock car no sway bar?
- A little help with the Brake fluid float sensor
- P0500 after cage install, I think I found the unplugged connector
- Installed new(used JDM trans) in my AP1 and cant get it to shift into 3rd or 4th
- Why are these TCTs so cheap? Anyone tried these?
- Resintall OEM TCT by unscrewing lock bolt?
- Brakes or Hub?
- 2001 S2K exhaust fumes
- Top Dead Center Help
- P0420 engine light code (cat) only 60k miles
- Help on draining gas
- Some of my Car Relays die on a regular basis
- Clutch pedal stiff after pop
- Clock springs
- TCT, Valve Noise?
- Need help installing OEM steering wheel in AP2
- Are oil pressure sending units interchangeable?
- Handling feels less precise than before, suspension 100% original
- P0122 - Nothing is fixing it!
- Horrible throttle response, downshifting sucks
- Strange noise from transmission/clutch?
- Burnt Cam lobes??
- F20 c oil consumption?
- How do I run coolant temp and oil temp/pressure aftermarket gauges?
- Advice on lower control arm Energy Suspension bushing replacement
- Start Button slow to start car
- Oil sump -> Clutch Housing Torque Specs?
- Help with diagnosing a creaking sound from the rear
- stock intake part number
- 2006 s2000 brakes/caliper
- 6 Tools it's Okay to Use Wrong
- Clutch Bleed
- Abnormal noise from rear only at 70 mph
- AP1 a.c. pressures are equal on both sides.
- help. fuel pump not coming on
- Clutch slave cylinder blown?
- AP1 fuse 23
- Brake Sticking after new caliper (need help)
- F20C with weird knocking sound
- Valve Adjustment Difference!
- Fender cutting for AEM v2 intake
- Luk vs OEM Clutch Master Cylinder?
- Need Help Getting An AP1 Head To Work On A 2006 S2K Block
- Need help on the parts
- Proper Torquing Tips & Techniques (as Suggested by Forum Members)
- Clutch failure (anyone had similar experience?) and recommendations for replacement
- Ap2 s2k Rough idle. Normal?
- EPS problems
- What makes the TPS squeal?
- p0135, replaced primary o2 sensor, i now get p0134 + limp mode
- Bare wire question
- PLEASE HELP! Need advise after botched head resurfacing job
- CDV delete without ap1 flywheel cons?
- Engine noise normal? Or lash
- Front OEM Pads - 45022-S2A-E50 vs 45022-S2A-E51 ?
- Seat connection to the car, 2006 model.
- Advice on condition of bore please
- Brake pads too small?
- Need help
- Another satisfied customer with Billman
- ECU reprogramming for key immoblizer after swap
- Help identifying between f20 and f22
- What to do before one year storage?
- Valve Adjustment Question
- Slight chirping or belt sound after hot
- Transmission play, seems like large backlash between gears?
- Multiple Cylinder Misfire and Freeze Frame Data
- Oil pan removal
- Engine rebuild - What can be re-used?
- AP2 EVAP Monitor tips?
- Ignition cutting out
- Gauge Cluster Brightness Issue