View Full Version : S2000 Forced Induction
- Solid Rear End Discussion
- Favorite Engine Management System (EMS)
- PRECISION TURBO - Flange? Oil return line fitting?
- Properly sized turbo for road racing/hpde reliability?
- Rev problem
- Speedo issue with V160 conversion
- PLX gauge ?
- header choice with s/c
- fuel guage
- ID2000's + single Walbro 255 + stock lines & e85 ?
- HTV1320 Supercharger Build
- AN hose for Wastegate ?
- Spring Nationals 2013 Juan's Turbo S2K
- car running slightly lean
- Turn on..Drive it... Turn off....Wont restart
- Intercooler Piping
- World Record Breaking Stock 2.2L 600WHP Supercharged S2K
- Eastern Hemishpere Fastest S2000
- torn on turbo choice
- stock exhaust modification
- Any old SC owners regret going turbo ?
- CC flywheel with FI
- Blow Off Valve Videos/Sounds?
- do the s363 and s366 have the same size compressor housing?
- Has anyone ordered the PTUNING Aluminum Induction AirBox System
- first turbo build underway looking for thoughts
- I need a vortech with id1000 tunes!
- best exhaust for a turbonetics turbo kit?
- e85 conversions?
- Moving VTEC and Ignition timing
- My piss off many S/C owners
- Anyone add a 2nd idler/tensioner pulley on the SOS kit?
- Borg Warner s256 vs s251
- Thinking about going SC, just a few questions
- Misfire CEL woes on Supercharged 06 with flashpro EMS
- Supercharger air leak sound after installing new pulley
- Which A/R to pick for my setup?
- CT engineering kit Novi 1200
- ATI Crank Street Super Damper
- power levels with log manifolds?
- Fuel Injector Development
- Catch tank setup
- anyone have any ideas why my car smokes on cold start **video**
- Tap turbo pressure source
- Help with a CT S/C kit
- Persistent P0133 Primary o2 Slow Response
- ROTREX SUPERCHARGER OIL -
- just got a gtx3576r. .63ar or .82 ar? Which should i use
- Has anyone ran these tires
- Neep help to get my car to the dyno
- My diesel turbo powered S2K
- Help with a startup map
- ScienceofSpeed Supercharger System
- Ferrari F40 - A Few Upgardes...
- Supercharger/engine longevity and durability.
- Thoughts on my compression
- Cross bar by the diff
- acceleration problems
- Vortech aem ems tunes
- ID2000 idle quality on E85? 12:1 AFR or more?
- Missfire or something else
- AFI Turbo WHERE ARE MY PARTS?
- Anarchy's Turbo Build
- High miles s2 on boost? is it worth it?
- Tracking/DD my s2000 AP2 need help.
- Transmission noise
- Question about exhaust performance and sound
- Kings Performance Yellow Bullet!
- need to change clutch
- SoS supercharger kit
- AEM's new Infinity ad
- turbo guys in CA
- ->My URGE build<- DYNO RESULTS PAGE 4!
- Calling out sp33d freak!
- Do you turbo guys have a vibration?
- my first turbo s2000
- First time ever at the track
- Things required/recommended for SCing?
- Walbro 255 fuel pump issues
- Aftercooler pump running, but car not on?!? Strange problem...
- Innaccurate Wideband Readings Between Gauge and EMS
- New to boost and looking for some tips
- ECU tuning/ upgrade for turbo 03 s2000, please help
- This Years Project Going From The Novi1000 To The Novi1200 And Replacing Valve Retainers
- gofast04's street build
- Best Ring/Pinion and LSD for 8.8 Diff?
- Kings Performance at it again
- 3.2" Comptech Supercharged S2000 (Dyno)
- Is my BOV not working?
- CTSC Cooler Pump and Front mount Question
- Ap2v2 timing chain cover on ap1
- contemplating an exhaust change
- Kings performance stage 1 or inline pro stage 2 street kit
- vortech v3 new install now running rough
- head gasket
- AFI IM discussion
- 1220sl How do I up Boost?
- krank vents AND oil catch can?
- Setting up GM bcs with AEM
- ati pulley belt size?
- COMP STG4 Clutch Cheap!
- Strange transmission problems
- Used Mase turbo kit, what am I missing?
- Fmw housing
- whats better open loop or closed loop boost control
- Quick question about "rigging" my own exhuast..........
- Where to install wideband O2 sensor (pic)
- delete please
- stat sync OFF . help!
- ACT HS2-HDSS with oem disc ,what tq is this setup holding cheers.
- HKS GT SUPERCHARGER
- Nitrous Dyno Help
- Borgwarner fit?
- No tune and I am still fine? How?
- filter options for fullblown turbo kit users
- Need advice to get a proper affordable clutch
- Anti-slip pulley, where to get?
- Installing Greddy Kit, just a few questions?
- Installing Greddy Kit, just a few questions?
- any one with stock trans out of the car ?
- 3" dual exhaust options
- Can a stock motor hold 450rwhp?
- Partial throttle misfire
- Comptech SC and Starter
- Best way to spend a extra $400 on my build?
- ID 1000 injector install (2000-2004)
- Has anyone put a th400 or glide in an s2k?
- buying a used FULLRACE kit with "everything"
- Kraftwerks Install with Reflash
- Vortech vtec sol oil leak
- AEM EMS D connector
- 13psi gt3076r 295/35/17 3 degrees Temp.
- Competition clutch problem
- Gt3076r horsepower question please help
- Advice on clutch
- Science of Speed (pulley sounds bad)
- SOS Users - idler pulley tensioner system
- max injector duty?
- 570whp mustang dyno on pump gas?
- Supercharger checklist!
- Hmm this looks familiar... Neeman77 rebuild thread!
- What boost are you guys leaving on at the track?
- Calling reputable tuners!
- Spal fan's initial startup issues.
- Clutch Issue?
- Clutch Issue?
- THUNDERCATS HOOOOOOO!
- Primary o2 sensor needed with flashpro?
- Turbo kit questions
- What Wideband Kit to Buy?
- Turbo kit and uk tunner
- Need Help ASAP
- Exhausts With Full Blown Ford 8.8 Rear End
- AP2 Kraftwerks Hi Boost realistic DYNO numbers?
- Which header are you using with your highboost sc?
- Display for Factory (06+) Wideband?
- Shifting with twin disc clutch
- "Regearing" SOS Supercharger
- FIXED! Newly installed Turbo now problems
- Any Tunning Shop for Boost in Dallas, TX
- Ptuning Oil Filter Relocation
- any one with a Whipple setup
- damn! wrong map sensor
- Stroking the Engine
- new track setup
- remote oil filter mount with turbo feed port
- Making Some Progress
- Fuel Feed Line Replacement in MY06+
- Vortech pulley and belt
- How much fuel psi from fuel line?
- how reliable is greddy ultimate
- What's the full parts list for ACT HD + OEM clutch?
- turbo ap2 s2000
- PTE 6262 on log manifold
- Tune
- Ford 8.8 Kit Fitment Issues - Installers/Owners please chime in
- BOSCH/ID1000 Injectors
- Nitrous set up in MY07
- Novi 1000 refurb
- My honda instrument gauges
- High Boost. What brake setup do you run?
- Tires
- Exhaust Manifold Gasket Question
- Carey Bales at NHRA Gator nationals
- Fuel pump and injector sizing calculator
- Advice for clutch
- Why NOT Boost?
- Id 1000 + aeromotive 340lph capability
- Full Blown Complete Fuel System & 2000cc Injectors
- Mac solonoid duty cycle
- Timing Chain Tensioner and FI
- Vortech leaking impeller seal - 928 seals bad?
- staying away from journal bearings?
- s2000 turbo parts
- Starting out on SOS and expanding... need some advice!
- splitfire performance turbo s2000
- Wasted fuel, cam timing, and injector phasing
- SOS stage 2 and shorter gear ratio
- How quick should Tial 44 wastegate bottom port leak down?
- best oem cam combo
- Exhaust notes - anyone has better sounding system?
- aftermarket intake manifolds with no iac solution
- ROTREX SUPERCHARGER POWER
- Duel Fuel Rail Setup on Intake Manifold
- Ctsc basic setup question
- Vortech V2 S/C map
- Overheating issue...
- What's the power ceiling for DBW Fuel Pump
- Which injectors for Novi 1200
- SOS STAGE 2 OR KRAFTERKS HIGH BOOST.
- Forced Induction Traction Experiences and Setups
- Thread size/pitch of water temp sensor!
- Wastegate spring
- Greddy turbo kit ap2 base map manage ultimate
- 1200cc injectors recommendations
- Ideas to tame boost creep induced by E85 on .82 AR 3076R
- Fuel... Meth, Ethanol, and RaceGas... AHHHHH!
- I have a Aem v2/v1 standalone?
- How much your Final AFM on boost/load
- Tua40278's New Build
- Best place to get exhaust manifold studs
- Greddy kit with AEM need base map
- Downpipe question
- Chicks driving s2k's.. What do u think about that?
- Walbro e85
- PTuning Scavenging Pump?
- Engine Bearings
- Is it hard to tune a supercharger yourself? Or expensive to get it tuned?
- -3AN or -4AN? oil pressure line
- 690rwhp stock fuel line record one walbro 400lph
- Big power! What kit and building internals?
- Help me with my turbo exhaust dilemma
- Need more power.
- comptech SC oil sump plug size?
- Do I need an oil restrictor?
- Upgraded Diff?
- borg warner input please !
- KW rotrex belt tensioner (picture)
- 1220sl oil leak
- Best Cooling Plate for Vortect V2
- Advice on oil sandwich plate
- Advice on oil sandwich plate
- Oil feed
- Making a heat shield ?
- Fuel Vapor Smell Under Boost
- Anyone running BW7670 EFR
- Aluminum Radiators and Low Profile Fans
- Vortech V2 install
- DEFI Oil Pressure Gauge and Oil Feed install Question
- twin scroll turbos and divided manifolds