- turbo help !
- Need help on setup
- Handling setups for Turbo Charged S
- microtec?
- Greddy Emanage ULT Harness Modification
- ACT vs INLINE PRO Clutches
- greddy turbo kit Ap1 vs Ap2
- Post your WHP with your STOCK rear
- 580whp & 360tq @ 19 psi
- who else makes
- New setup and numbers-Evans Tuned
- Gears + Boost
- turbo build
- 3 bar/2bar map sensor
- Kraftwerks Boost Curve question/problem?
- GT35R pfab log 3" exhaust AEM 2mm HG
- TCT issues with SC?
- quiet exhaust + good power exhaust for Greddy Kit
- Need help with clutch master cylinder
- UNOFFICIAL: CLUTCH vs. WHP thread
- Driveshaft Problem
- Why build a motor when u can get Mase'd?!
- Spark plugs, for every heat range difference
- greddy guys post up
- aem serial gauge
- anyone heard of this turbo kit..
- couple of questions
- Trouble with AEM water/meth injection
- 4" exhaust?
- New numbers... 522hp/300tq
- Greddy Owners MAP relocation help
- Connecting to AEM EMS when not in car
- Tuning once a turbo is installed
- Clutch Install DIY
- Virginian FI and inspection
- New build
- InlinePro manifold work w/ Godspeed Intercoole kit
- AEM Tru-boost Gauge-type controller
- FIC HELP! 2 units and same CEL
- FIC HELP! Two units, no luck!
- i need help with running oil lines an coolant
- Buy a used S/C?
- new to forums need some advice on turbo, etc
- I'll be the guinea pig...
- Need some help with build
- which turbo kit to get?
- str manifold
- 10 psi gt35r ?
- Mase Engineering S2000 Turbo Kit Introduction
- Engine not staying on after start, HELP! VID ADDED
- Engine not staying on after start, HELP! VID ADDED
- Low Compression Pistons with Stock Bore
- Fuel Return system needed?
- are AEM standalones legal in NY?
- TPS PART#?
- WTF Kit is this?
- exhaust cut-out
- EMS 1052 Non-UEGO
- Head Gaskets and Quench
- Blown Kraftwerks Rotrex charger?
- AP1 flywheel/CC Clutch stage 2
- RC injector query - SL vs SH...
- Going to Get a Turbo on my new s2k soon.
- Fuel Pump Install - GReddy kit
- Thinking greddy kit, What managment to go with
- Boost
- Water to Engine Oil Cooler - KW Owners Chime In
- best manifold?
- Where can i find this oil adapter?
- last week til FI
- intercooler
- which manifold is this
- deleted
- Has anyone done cams?
- Correct O-ring size for RC injectors
- whay type of exhaust yall runnning?
- benifit of aftermarket exhaust
- Compression test results 160-160-160-110
- AEM water/meth injection !
- maybe it'll be in the faq...
- grinding noise
- Turbo vs. Supercharger
- HELP major turbo dramas
- Something New
- RevHard Manifold/Ultimate Racing Downpipe Compatibility
- switched to aem 3.5 bar and have some info
- need turbo suggestions
- who uses stock oil cooler/heater?
- oil feed and water line routing?
- Placement of Emanage with Greddy Kit
- Should I shield the carbon fiber hood?
- help with relocation kit
- Sold my turbo s2000 friday than got the call :0(
- aem ems throttle tip in adjustment
- Attention owners of Stage One Tuning Superchargers
- Inlinepro oil filter relocation kit
- Desired AFR on spray
- Who's runnin 4" exhausts?
- Comptech Supercharger w/aftercooler...
- Anyone in the S.E. USA interested in a Mase tune?
- Vacuum values
- need help...comptech s/c
- need help...comptech s/c
- Thinking of a small nitrous setup
- GReddy eManage- OBDII accessible?
- anyone have ASP 3.8 pulley to come with the belt?
- Science of Speed Pulley
- AEM 1052U & Wideband AF Gauge?
- Quick question on EMU
- Knock question on ems
- 2004 S2000, AEM Water/Meth Injection UPDATE!
- Looking for Vortech Billet Intercooler Cap
- How to Build a Turbo Kit On a Budget
- I need cooling tips and tricks
- Greddy Kit Vibration Issue
- Custom Header Work for SC'ed S
- AIT temps?
- help
- finally got to the drag strip
- Supercharger: Aftercooler vs Intercooler?
- pfab tubular manifold pics?
- How to Tune and Modify Your FI S2000
- SC'ed s2000's
- Pics of my SPARK PLUGS, how do they look?
- Test on different exhaust !
- Best bang for your buck for a Turob kit
- Supercharged
- E-manage Ultimate.....
- New numbers for SFV !
- Greddy Turbo Kit
- Twin Turbo S2000 by Epic Tuning
- Update numbers for 59/65b inline kit
- Vortech SC pulley..
- What else should I get with this
- New 70mm Test pipe for you FI Guys
- Bought a emanage ultimate...
- Aem meth "boost safe" wiring!
- Pfab /Inlinepro vs. Greddy kit
- Change of plans
- Funny you can buy a vortech sc at amazon
- Fastest reliable (for the most part) s2k?
- Powerband with Comptech SC
- Relocated my battery
- 10lb pulley or go turbo.....
- 5 bolt exhaust vs. 4 bolt exhaust
- E-Manage Ultimate to AEM Standalone.
- I have a few Turbo questions
- ap2 boost guage?
- Upgraded Ignition System Replacement On a Budget
- Budget for Greddy Turbo? or anything else?
- Lean Fuel/Air
- connector A?
- turbo plans - the safe reliable setup
- best supporting mods for Greddy kit
- Hp Performance Turbo Kit
- What's your water temp on your Turbo S2k?
- Max boost on stock block
- My Turbo project
- Opinions On 3mm Headgasket Or Water/Meth
- S2K turbo kit?
- Question for those of you who've gone turbo
- SOS kit installed and pics
- CEL with Hondata?
- Need help. Greddy Oil relocation kit
- Electrical problem...any help?
- Basemap for Revhard Stage 2 kit?
- ARP exhaust manifold studs.
- Installing ARP head studs
- intercooler help...
- oil shooting out of BOV?!
- Kraftwerks SC with Laminova cooler
- Supercharged s2k's with 6 puck clutches
- ZEX direct port kits
- First passes with the GT30
- Red Star Motoring S2000 NEW WORLD RECORD!
- Anyone using holset turbos?
- Can you stomach another clutch thread?
- Another H2O/meth location....
- Need help with E-manage
- Oil relocation wont fit?
- OEM MAP Sensor with Supercharger
- Springs & Boost ?
- idle air control valve or what
- Throttle Body Question
- JBK performance
- My turbo build
- UnOfficial Dyno Thread
- How much for this partial kit
- KOYO Radiator cap
- Video of 500+WHP
- nitrous?
- need help choosing high flow cat
- AEM EMS Users
- Kraftwerks USA in Norco:
- Flex Pipe size ?
- EMU and cylinder misfiring
- my custom turbo s200
- a quick little teaser
- Question about AEM Wideband Installation
- greddy support software
- need info on e85
- CTSC AfterCooler alternative
- S2000 GT35R@13psi
- Inlinepro 3mm head gasket question
- SOS Kit AP2 dyno results!
- 704whp s2k
- My Greddy Turbo Kit AP2 dyno results!
- KW intercooler
- Sos sc youtune, decent tuner in Germany?
- aem ems vss calibration
- Intercooler piping
- New tune with race fuel
- 15lbs from stock internals
- Those with InLine Pro Diff Kit
- Comptech at 10psi
- Machining Factory Crankshaft + Oversized Bearings
- whats a fair price
- best coating for intercooler piping?
- Maintenence before going FI
- ScienceofSpeed Supercharger System: 403whp 262wtq
- comptech supercharger
- HKS SSQV fitment Vortech
- Highest whp on supercharger without using a...
- RC 750
- Super Charger set up?
- Another SOT install thread......
- Replacing TCT with VTSC
- Wiring Diagram
- Accuracy of OEM MAP sensor
- Battling t3h heat
- Updates on my turbo setup
- VTEC Solenoid sticking? Damaged?
- what to do with pcv
- Fuel rails with nitrous port?
- Watercooling turbo
- Disconnecting batter to car and Emanage Ultimate
- AEM Serial Gauge programming
- dont knoe wat to get turbo or supercharger
- clutch slipping
- dyno?
- intercooler piping question
- The Unofficial GT3076R Greddy Turbo Kit Upgrade
- my built turbo s2k.
- A/C relocation
- aem ems
- CTSC/AC
- Vor-Tec Blower Sputter and won't go pass 6k
- Help on diff and transmission set up upgrade
- My Comptech S/C Tuned -- 362hp/203tq (13psi)
- bosch 1000cc saturated injector issue