View Full Version : S2000 Forced Induction
- krpo issue or should I look else where?
- Coreys Turbo Build
- Boost leak detectors
- Divided T3 manifold options?
- Clutch pedal wont move after install! Help
- Good Ole Mase Turbo Kit Question
- P-Fab Turbo Kit with Return line in the front of oil pan?
- Aftermarket rad, cooler thermostat, air deflectors, STILL TOO HOT....
- 05 Supercharged Haltech PS500
- Precision 1000cc injectors...
- cheapest place to get precision 6262?
- Pfab custom flex mid pipe
- Interesting fact I just found about Precision turbo V Bands..
- Awesome Video! Mon Stand ScienceofSpeed Supercharged S2000 in France
- Walbro whine
- Gear-X final drive and transmission
- Oil pressure gauge issue
- V Band clamp..
- Valvetrain recomendation
- Turbo Coating
- renting truck to pull trailer options
- Where do you mount gauges
- I am going to need installation instructions for my 2001 comptech supercharger kit with aftercooler instructions, and the electronics wiring instructions.
- Just bought a basic Comtech Aftercooler Supercharger Kit, what is the largest pulley possible with FMU?
- Turbo s2000 caught fire
- Loss of fuel pressure...
- Supercharger supporting mods
- In car video noooooo tractionnnn :)
- car wont start.. what can be the problem?
- What is everyone doing with the oil coolers?
- How much should a 25F swing in Temp effect AFRs?
- SOT supercharger for my racecar
- NEEDED AEM D Connector!
- Fuel Pressure Regs & Gauges
- Belt slipping
- Cool Turbo Setup
- Dipstick popping out with new S/C kit
- Coolant lines off factory oil plate
- J's header HP gain results are in!
- WTF, car is all over the place WOT abobe 100MPH
- ATI Super Damper
- aem boost control solenoid
- Boost controller reset?
- Turbo kits Brands
- Full Race Build
- battery/fusebox relocation question
- How do I get the Mishimoto Cooling plate to fit with
- Greddy Turbo kit. Cold air induction mod.
- need some quick advice
- Strange problem
- best exhaust for turbo?
- SOS stage 1 - not getting 9k?
- full blown oil filter relocation kit
- Toda cam fail
- Man, am I glad I decided to build my block...
- What plugs, oil, and restirctor?
- Hot Rod Class - 14th Annual Sport Compact Fallnational
- AP1 Comptech SC on 04 AP2
- GTX3076r vs FP HTA GT3076R
- FB dual hanger install help!
- quick question
- Weighing SCs - Comptech / SOS
- Radiator upgrade for turbo?
- injector o rings
- MAP Voltage
- How Do My Plugs Look?
- Greddy EMU and Missing Link questions
- Dyno tuned finally!
- turbo 6262 vband down pipe wtf need help
- Anyone know which injectors these are?
- Wastegate Set Up
- Kraftwerks Supercharger 06+
- SOS initial dyno...looks great, but...
- How many devices can you run off the fuse panel?
- Precision turbo choice
- Daily Driven?
- What can I take out!
- Have AEM EMS need Wideband
- oil return 10an or 8an 1/2 npt or 3/8 npt
- newer oil jet bolts (4 holes)
- My first turbo build
- drivetrain and transmission solutions for 550+whp S2K's
- need help with injectors clips
- Built bottom ends? Who to go with?
- Kings Performance Street S2King goes 9.9 @ 142mph
- S2K wire harness
- Another blown Engine! Some insight please
- SC aftercooler rad Spearco
- Mase Turbo Kit
- Comptech Black BOX
- CT A/C fitment on MY06+ DBW issues
- Fuel consumption with SC?
- I want boost.
- Another one down
- Upgrading from 7psi to 9psi CSTC+AC
- need a base map for AEM EMS
- Need some advice
- Wiring AEM Boost Solenoid with AEM EMS (Help)
- Huh.. Maybe AEM issue?
- oil feedline for my turbo
- Coolant temp sensor possible differences?
- Heat Exchanger to pump to aftercooler hose help
- Boost for my race car
- Why did you hate your SC?
- Can I remove my EGR/ secondary air pump system..
- Did I miss anything?
- Enough for E85?
- Opinions on what should go into a built head.
- Vortech T Trim upgrade
- Impeller Speed Calculator
- New SOS install...how often should I tighten the belt?
- Smoking issue. Posting again. SC is leaking. No oil in tb, or outlet of AC..
- Stupid question...
- BDL fuel rail FAIL!
- anyone have the old comptech sc kit?
- Where can i buy a s2k turbo manifold flange for making my own manifold?
- Mondo bov to replace race bov
- mvr 44mm westgate installation
- Pulling valve cover
- Issues with MAC boost solenoid
- the destruction pics
- Vortech part List...
- SC: Time to Change Oil?
- 2.5" - 3 " downpipe (just off of the flange)
- Damn this turbo!
- ***Video*** The Spectacle goes around the block
- Oil question
- Vortech idle problem
- Went Turbo but want more power!
- Think I have it all..
- Bolting manifold to head?
- Pfab ELT manifold vs Mase Engineering Manifold
- adding more boost with CT SC and need some input
- Nitrous lean shut down switch..What AFR to shut down at?
- Planning to go FI; have a few questions
- PFab Top Mount with a 5857
- The First 700hp GPW CR
- CC Stage 4 life and 700hp
- after market trans mounts
- oil drain precision turbo flange
- 3mm headgasket and woodruff keys?
- Comptech SC
- Immobalizer problem 2 days after tune
- Crankcase vent puffing smoke?
- Misfiring Problems
- Aem and comptech fmu
- Another diff bites the dust!
- GT30R restrictor
- Pictures of S/C oil drain
- AP2 Greddy CARB, and what to buy?
- Need help with installing my new sensors
- Best bang for the buck clutch..
- wideband broken?
- PFab contact issues?
- 928 Motorsports Impeller upgrades for Novi 1220/1220 Blowers
- Upgrade Diff Mounts?
- Who cut their hood?
- CLOSE THREAD SEATBELT WARRANTIED W/ FREE CAR WASH
- 1/4 mile times
- Oil Drain Opinion
- Waste gate opening and closing?
- Vortech Supercharged AP1..
- Thinking of spinning the vortech blower to 15 psi.
- Aftermarket Radiator
- Question for Comptech and SOS owners
- aftercooled sc setups. What are your intake temps?
- Comptech sc owners with after cooler
- 3" flange/piping into oem catback
- Water shoots out exhaust during start up?
- S2000 vs 150 shot of Nitrous with Q16 race gas
- turbo manifold studs
- Any weekend warriors run racegas only?
- E-manage problems please help
- miss fire problems
- thinking about upping the boost
- headgasket question.
- How to rotate turbo?
- Need help identifying turbo
- comptech tension bracket
- cc stage 5 clutch chatter?
- Final Tune - 670whp / 500ftlbs
- inlinepro or full race kit?
- catch can drain
- Rear options for 350hp
- Inline pro oil feed and return
- Need nitrous fill locations in PA
- ID1000 Install Help
- puddymod diff?
- Stutterting with ems
- vortech supercharger AP1
- Tap the timing chain cover for oil return?
- down pipe fabrication with ramhorn
- Manifold bolts sheered off
- turbo question
- Mishimoto Radiator + CTSC = rubbing
- 2 boost settings
- Head gasket for turbo ?
- Coming Soon
- Mounting the Comptech S/C Airbox
- Turbo Wide body S2k (new project)
- Future Turbo Build
- Turbo 2.0 with 2.2 cams?
- How do you install AEM Boost Solenoid?
- Anyone running a Fidanza 4.3 Clutch kit?
- Running dual Walbros on stock ecu, stock injectors, etc...
- 2.5l turbo, engine rattle, vid included
- What fuel pump comes with Vortech kit?
- Thank you LJ (FBM) 513 hp and 317 tq
- HELP! Car wont start for some reason! car died on highway again....
- Stock block +CTSC
- Brock's COMPLETE build: Mase 62/62 turbo kit on E85
- PFab top mount manifold and fuses
- supercharged/ Header options
- Driveshaft shop 1-Piece Aluminum Driveshaft
- Still having problems help needed guys.
- High flow cat
- RB26 powered S2K ran a 7.62@ 174mph
- Cheapest place to buy Vortech V2 Tuner Kit
- turbo oil lines/fittings/bungs
- What Cutout are you using?
- greddy turbo kit ! PLEASE HELP !
- GREDDY TURBO! Help pleasee!
- Best turbo for daily driver
- How to shop for a used supercharger?
- Cam Timing with Supercharger
- precision 6262 with ramhorn
- Help please
- Stock Limits for Boosted S
- Exhaust options
- Vi3tboy's S2000 Dyno Tune
- forced induction
- running too rich
- need help for comptech supercharger aftercooled water pump
- Need Help ASAP with Oil Leak from Turbo
- Changing Turbos this Afternoon
- Spun bearing
- Which BOV do you like and which do you hate?
- Tech Article: Importance of water cooling your turbo
- NEED Greddy turbo kit MAP For AP1!
- Oil Choice
- My S2000 build
- Is the SOS 3 bar MAP a rebranded Omni 3 bar?
- my new catch can!
- Vortech tuning issue
- Driveshaft Question
- BOV/Supercharger
- Sad day, too soon
- 3" downpipe for MASE kits?
- Weak point of engine?
- first initial startup check engine light and oil pressure light