View Full Version : S2000 Forced Induction
- Vortech bypass valve question
- supercharging ap1 would like to know what mods i need to have have a reliable car and have no/ little worries of engine failure
- Lifting the head or coolant system issue?
- AEM 3 bar map sensor
- Stage One Tuning
- Ctsc SOS 3.8" pulley belt
- Possible Problem?!?
- comp turbo oil-less turbos
- Some more S2000 Testing!
- What MAP sensor? Please advise On AEM EMS
- Twin Charged S2K!
- F20C Build questions/help
- Is it worth it to add an inter cooler to a SC setup?
- Can I run id1000s on my stock ecu?
- Leaky catch can lines
- AEM EMS..or NO?
- In Car Video from the Track
- Which Meth Kit to get?
- Is this AFR too lean for idle?
- Greddy Turbo users that are still running Emanage Ultimate...
- installing FPR
- What Cooling Plate
- Parts for my custom turbo build - Thoughts?
- Stock Clutch rating
- Help finding a twin scroll turbo kits
- 1/4 mile times for SC S2000's
- All wrinkle black Vortech kit plus 928 motorsports v-impeller upgrade
- My build/learning thread
- The new S2000 trend of the year.
- Is there an ETD that will work with a comptech supercharger?
- 2 questions regarding my comptech setup
- Finally boosted my s
- Turbo oil feed fitting sizes
- Borg Warner EFR and S hybrids?
- keeping my motor cool-help
- What size OD is the intake manifold?
- injectors for Vortech V2 watercooled supercharger
- My aem 3.5 bar map sensor ,mounted correctly ?
- Tryna Boost?
- Engine removal questions
- Comp Twin plate adjustment
- Where to buy 6 bolt to vband adapter
- Which Kit? (Poll & Experience Welcomed)
- Gates fleet runner belt for Vortech
- AVID Rear Diff Mounts
- Some video of my Car (testing new Video Camera)
- Asked Rotrex if they would come out with a new C30
- Waste gate question?
- Supercharger worth it?
- changing to E85, what else do i need?
- Whats your guys opinion? Think I'll miss boost?
- Fuel leaning above 7800rpm, need ideas
- well second attempt at the strip ends in failure
- Where can I buy titanium VTEC solenoid bolts for Vortech kit.....
- Pulling motor Saturday
- Humble S2K
- return line
- Turbo done right
- Amsoil fluids w/ supercharger
- Re-tune necessary?
- Where to buy a 4" vortech pulley?
- head gasket
- Manifold to work with RHD?
- wastegate PROBLEMSS
- *SOS Supercharger Review*
- Anyone know a fuel pressure regulator that uses the same size fittings as the Comptech rrfpr?
- down pipe problem
- How Much boost are you running on 11:1 CR and pump gas?
- SOS BOV
- help with BEP batmowheel turbos
- What clutch/pp are we preferring? SoS Stage 2
- Got Tuned Sat. Thanks Jeff Evans
- Crankcase blowby thru oil filler on superchrged AP1
- Running Turbo coolant lines direct off radiator - Update***Headgasket went!
- Egt committed suicide
- Feed and return OIL lines, precision 5857, pfab log
- need help about installing a S/C or Turbo system on my s2000
- Spacers needed for ID2000?
- TURBO GURUS Help Critique etc. oil in exhaust.
- Heat soaked intake manifold
- Spark plugs
- The rusults are in! Just tuned her today :) Dyno Chart and Video inside
- Comptech tensioner bearing?
- Driveshaft leakage from boost?
- SOS stage 2 do I have everything to do it right
- S2000 Differential Durability with SOS s/c
- Thoughts/Opinions
- ETD for superchargers S2000's
- ATI F20C/F22c Super Dampers
- Need help with these injectors
- RC 650cc injectors with emanage ultimate
- Science of Speed SC SOUND
- Need suggestions for upgraded heat exchanger
- TX2K12
- Need help IDing these injectors
- Looking for a Modifry's ECT for an ap1.........
- Anyone running the PFAB Stage 3 Intercooler?
- Returnless system fuel pump
- What size exhaust housing for a divided 6765?
- Mishimoto Radiator Install
- Trying to decide on Gear ratio 3.9 or 4.10?
- twin rotrex placement idea
- Do i have everything im suppose to so i can go vroom vroom psh
- Trans problem
- Question on Map sensor & Diverter valve
- I want to go e85 BUT
- Full Blown FTW
- Next up clutch
- E85 vs 93&meth
- Be leery of stock AP1 retainers
- Developed an AFR issue and bogging after a hot day and 230miles.
- Blown Garrett turbo, need advice!
- hi guys i'm new to turboing S2000's Need help!
- Slightly better time at the Track (1/4) 12.0 @ 127
- Fan and AC Inoperative
- Any supercharged guys running an aftermarket radiator and slimline fan?
- Clutch advice
- Why is this happening? Connecter is blowing off from
- Comp Clutch twin install help
- Comp Clutch twin install help
- boost limiting valve for SOS supercharger
- Relocating the fusebox without having to extend any wires?
- Turbo Manifold/Turbo Questions
- Should I be worried
- Upgrading Comptech
- Manley turbo tuff rods
- Turbo question
- dss 2.9 axels
- Do I need to calibrate my gauge ?
- Comptech and Synapse Syncronic BOV Install Question
- S/C owners
- Cold to hot weather PSI variation?
- Turbo Vs. S/C
- Is my boost gauge going bad?
- Opinion on a clutch for a 400whp sc'd car!
- Got my Greddy T518Z rebuilt... happy with the results (pic inside)
- InlinePRO solid engine mounts
- How does this kit go for?
- aem series 2
- Do I need an aftermarket FPR?!
- high pitched whining noise
- Pulled motor apart to find...
- NEw to the turbo world
- Warm weather and smoking engine in built engine
- Boosting Guru's
- S/C and Tuning
- Comptech rrfpr without blower?
- has anyone seen or bought this?
- 62-1
- aem v2
- Went to the 1/4 mile with Supercharger. LOW Trap speed?
- Can't Decide on which clutch setup!
- no luck at the strip tonight
- thinking of boosting again
- Either I'm an idiot
- Buying a S2k with turbo built engine (no turbo on it)
- 2006 Comptech SC Kit
- Just got home from the dragstrip.
- Intake temps climb rapidly between sessions
- trying to find heat shield part number
- journal bearing vs ball bearing
- Do you regret boosting?
- Ultimate racing kit issue.
- Swapping Dbw ap2 motor and trans into ap1
- Turbo exhaust question
- ScienceofSpeed Supercharger System - March 2012 Sale
- Quick question/advise needed on what SC kit to go with!
- Hood clearance issues with Comptech Aftercooler
- IllestRolla's 03GPW Boost/Build * v2.0 2018 Updates*
- HFC vs Test Pipe
- Comptech sc basemap
- DEI Exhaust Wrap
- C38-91, to big for my needs?
- What's more important to monitor? Fuel pressure or oil pressure
- Recap of My purchases-Anything missing?
- Updated numbers with Kenne Bell BAS & BAP
- Rear diff gear
- Replacing Greddy Turbo T518Z
- AEM EMS V2 vs Haltech PnP
- FBM Delrin Rear Lower Bushings
- removing greddy turbo kit
- Can i use an Comptech AP2 rrfpr on a AP1?
- Cheap but effective gauges
- OEM Injector clips
- Vduber's build
- Map sensor reading high, overfueling
- Newbie turbo install, need help guys!
- Condition of used turbo?
- Comptech rattle on cold start
- Last few S/C questions....
- Street tuning dyno result - Ptuning kit
- Finished my Vortech V3 Build AP2 *UPDATE DYNO
- evap and fi, hows it done?
- Reputable machine shops in ny
- tps sensor
- Supercharging
- used greddy kit
- Comptech S/C 3.8" pulley
- Is my power too low?
- Supercharger kit
- Comptech FPR banjo bolts
- External or internal (radiator) oil cooler
- heads up for anyone considering buying the inline pro stage 1 kit
- Full race oil relocation lines
- Blitz DTT
- My journey officially begins
- Full Blown 8.8 Rear End Kit
- SOS SC install instructions
- Supercharger and exhaust piping
- Help me win Avid Mounts (FaceBook competition)
- wanting to join the dark side!
- Saikou michi dual catch cans and vortech SC
- SOS Throttle Body without a tune.
- Centrifugal Supercharger installation guides and links. Parts & Pricing sheets.
- An Eight-Speed Manu-matic Like This in an S?
- JMS Racing Stock Block Dyno and Track Video
- BACKLASH SETUP
- Throttle body/Manifold
- Need comptech supercharger install instructions
- How to tell real or fake garrett turbo
- WARNING -- INNOVATIVE MOTOR MOUNTS
- Looking for Ap1 Base map for a greddy turbo kit
- HKS BOV on my Novi 1000 sc...
- CTSC AP2 HP
- My Turbo CR Build.
- ? Easiest Turbo Kit to Return Car to Stock ?
- turbo, now ac doesnt work?
- looking to go forced induction but....
- how to tell the difference between vortech kits?
- Does the front bumper need to be modified to allow intercooler to be fully exposed?
- car value
- NEED FEEDBACK ASAP
- s2knoob's Turbo Build
- Supercharger upgrade options?
- vtec pressure switch bypass
- Looking to turbo
- jpetch05 turbo build
- Anyone ever use this exhaust on a turbo application?
- quick s/c questions
- So I plan to get my hands on a Kraftwerks kit, would you use SOS or KW?
- Found these in my toolbox, what injectors and AEM MAP are these?
- Cusco lsd 1.5 80% trys to kill me with 420whp
- Stock compression 500+ ideas
- Log setup vs supercharger dyno overlay
- Gtx35r vs divided 35r 1.06
- Greddy turbo rebuild question
- Main and rod bearings, hmm...
- Supercharger questions / Which components/parts will i also need?
- Intercooler writing
- Wastegate Springs & Setup